![]() It's tool box liner over a layer of 3mm black PVA foam.Īfter that I stripped the whole gun down to start ageing the frame and fix some other problems that have popped up. I've also started experimenting with the lower lining. Rocket complete! I vapour blasted the rocket body too. I neatened up some of the edges and sorted out some problem areas before spraying the white primer coat. ![]() (If this isn't visible, please open in new tab and you'll be able to view) Surprisingly it doesn't need anymore! Really good firm hold with this method so I'll leave it there, especially as I cannot find any evidence on the film props that they were secured in other places. I then put my shell into place and squirted in a load of epoxy glue inbetween the shell and tab. I made some angled tabs and first screwed them to the horizontal trim. I also had to finally fix down the top shell. Not much room for inaccuracy here but it just fit right in there. I included tabs on the bottom of the fins to aid in gluing. The fins were then set in a jig to make sure they're square and glued internally with 2-part epoxy glue. ![]() I used a slitting saw on my mill to get a nice thin groove. The rocket needs its aluminium fins attaching. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |